To construct the rail sections, Jeff first started all the screws for the spindles in the top rail. The top and bottom rails are pressure-treated 2x4's.		Next, he cut all the spindles from pressure-treated 2x2's.
He then drilled pilot holes in the centers of each end of the spindles, and fastened them to the top rail with the starter screws.		The bottom rail then got starter screws for the other ends of the spindles.
Lastly, the bottom rail was fastened to the spindles with the starter screws.		Here's another set of spindles ready to be attached to a rail.

BACK TO OUR LOG HOME MAIN PAGE

If you have any questions about this website, e-mail us at stargazer@stargazerpics.com.